Dog Collar Part 2

The next dog collars on the list are Herm Sprenger chain collars, commonly referred to as choke chains. These collars are a slip collar and we carry two different types; the traditional chain that slips over the dog’s head and the toggle chain that can be put on around the dog’s neck (like a buckle collar).

Choke Chains are not considered a general purpose collar and are usually associated with correction or aversive training techniques. If you are going to use this type, it is important to know how to properly size, fit, and use it… And never leave a choke chain on your dog as a regular collar.

Let’s start with the construction of the collar. Herm Sprenger chain collars are made of durable, high quality, chrome plated steel for beauty and long life. All rings and swivels are stamped with HS-Germany, Germany, or HS to ensure you have the real thing.

Next, a properly fitted choke chain is very important in training. It should be the size of the dogs’ upper neck plus approximately 2 inches. Sounds simple right? Well… not always. Here are some common pitfalls:

  1. Many dogs have a head that is larger than their neck (Mastiff type breeds for example). If you only consider the neck size and don’t check to see if it will also fit over your dog’s head, you may be unable to slip the collar over your dogs’ head. That is where the toggle chain comes in handy… Instead of having to slip the collar over the head, you just put it around the dog’s neck and slip the toggle through the end ring.
  2. It is also important to know how to properly put a chain collar on your dog. Hold one ring horizontally (like a basketball hoop) and then drop the chain through that ring. Then, facing your dog, hold the collar so it forms the letter P and slip it over the head. It should not sit below the middle of the neck and it should have a little slack (approximately 2 inches).
  3. What can also be confusing are the collar measurements themselves. First, Herm Sprenger chain collars are measured from end to end (including the rings). Next, and here is the rub, those measurements are not exact. What does that mean? It means Herm Sprenger chain collars are a fixed length based on the size of the links and rings. So when they list a size, they round up, or down, to the next whole measurement. For example, a 20 inch chain collar, actually measures 19.75 inches. However, since these collars are not designed to fit based on an exact size and require slack to function properly, that .75 difference has virtually no impact, it is just something to be aware of.

Now if you are trying to measure a collar that you already have to either purchase another one, or get a different size, you will now know which collar to purchase based on the information above. To recap, lay the collar out straight, measure from end to end (including the rings) and then round up or down to the nearest whole size. For example, if your collar measures 21.5″, take a look at the sizes available for your particular collar (20″, 22″, 24″) and choose the closest whole size, which in this case would be 22″.

I hope this helps you choose not only the proper type of collar but also the proper size of collar. Again, if you decide to use a chain collar, remember chain collars are not considered a general purpose dog collar. They are a training collar and you should never leave a chain collar on a dog unsupervised or when you are not actively working with it.

Herm Sprenger Chain Collar

Leave a Reply

Your email address will not be published. Required fields are marked *